High Volume* | Low Waste* Portable + Wall
Mountable Reverse Osmosis RO DI Purifier
We supply these systems with a manual first flush valve (see image 13) so you can direct the first bit of water produced out the waste line then through the RO to which allows resin to last longer. This flush valve can also be set to increase your operating waste ratio which is required in some areas where the TDS of the local water is high.
* high volume pre-membrane filters and resin cartridge can handle higher volumes than the standard filters allowing less frequent filter changes i.e. with these systems standard pre-filters will need to be changed every +/- 7,500 litres produced and high volume pre-filters every +/- 25,000 litres produced.
* 2x RO membranes connected in series to reduce average waste from +/- 60% to +/- 30% [waste from 1st membrane is purified by 2nd membrane].
Depending on variation selected in drop down menu above we will supply as follows
|
Item
|
Flow Rate
24 Hours
|
Water Inlet Connector
|
Recommended
Use
|
|
RO-5-DJ
75G+50G
|
100GPD
380LPD
|
Sink Mixer & 1/2” + 3/4” Garden Taps
|
Marine + Some Freshwater Aquariums
|
|
PRO-5-DJ
100G+75G
|
150GPD
570LPD
|
Sink Mixer & 1/2” + 3/4” Garden Taps
|
Marine Aquariums + Some Freshwater Fish Tanks
|
|
PRO-5-DJ
150G+100G
|
225GPD
855LPD
|
Sink Mixer & 1/2” + 3/4” Garden Taps
|
Marine Aquariums + Some Freshwater Fish Tanks
|
|
PRO-5-DJ
180G+150G
|
300GPD
1,150LPD
|
Sink Mixer & 1/2” + 3/4” Garden Taps
|
Marine Aquariums + Some Freshwater Fish Tanks
|
Note: Testing of flow rates, waste ratio's and TDS readings were done with water at 28 degrees Celsius, 80psi water pressure and feed water with a TDS reading of 105ppm.
This system is locally assembled using high quality approved parts
SYSTEM INCLUDES:
- Powder coated, mild steel folded bracket
- 3x 10"x2.5" white opaque or clear tinted filter housings [vertical ones]
- 1x 10"x2.5" 0.5uM poly spun sediment filter
- 1x 10"x2.5" Matrikx CTO high volume carbon filter
- 1x 10"x2.5" jumbo post RO mixed DI resin filter [2.5x as much resin as in line post DI filters]
-
2x high quality reverse osmosis membranes connected in series [flow rate depends on selection in drop down menu]
- 3x meters of high pressure 1/4" | 6mm water filter tubing
- 1x opening + closing housing ring spanner
- 1x standard* sink mixer diverter connector
- 2x garden tap connectors for 1/2" + 3/4" taps
- 1x manual first flush valve
Supplied with a tap connector to fit 1/2" + 3/4" garden taps [measures 20mm + 25mm in diameter respectively] as well as a standard* sink mixer diverter valve
* Standard mixer taps refer to a mixer tap where you can unscrew the aerator on the end of the tap and will be left with either a 20mm female thread or a 23mm male thread. If you have the 20mm female thread you'll need to use the inside to outside thread converter [supplied with the diverter valve] to connect but if you have a 23mm male thread after removing the aerator you won't need to use the thread converter
Easy to carry around and great for topping up freshwater aquariums, caravaning, camping and home use + produces 190-685 litres per day depending on mains water pressure, feed water quality and system selected
The reverse osmosis process results in the purest possible water and results in the total dissolved solids (TDS) count dropping by between +/- 99.9% and 100% with a post membrane DI
This purification process is commonly considered to be the most effective method of purification available to the public, and will consistently produce the lowest level of contaminant.
RO will reduce/remove all of contaminant in the feed water including chlorine, fluoride, volatile organic compounds, disinfection by-products and heavy metals
See below table for effective reduction of common contaminants:
|
ELEMENT/COMPOUND
|
% REDUCTION
|
ELEMENT/COMPOUND
|
% REDUCTION
|
|
Barium
|
99.9%
|
Potassium
|
100%
|
|
Bicarbonate
|
100%
|
Radium
|
99.9%
|
|
Cadmium
|
99.9%
|
Selenium
|
99.9%
|
|
Calcium (Hardness)
|
100%
|
Silicate
|
100%
|
|
Chromate
|
99.9%
|
Silver
|
100%
|
|
Copper
|
99.9%
|
Sodium
|
100%
|
|
Detergents
|
99.9%
|
Strontium
|
99.9%
|
|
Fluoride
|
100%
|
Sulphate
|
100%
|
|
Lead
|
99.9%
|
PCB’s
|
99.9%
|
|
Magnesium
|
100%
|
Insecticides
|
99.9%
|
|
Nickel
|
99.9%
|
Herbicides
|
99.9%
|
All of the parts that come into contact with the water in our systems are manufactured from BPA free food grade plastics. All of the filters and parts that we source are of the highest quality and meet the required quality standards.
Membrane brand/s of the membrane supplied with the system may vary depending from those depicted what we have in stock but will be of equivalent quality
This RO system is a multi-stage pumpless system. It is designed to operate on mains pressure and will produce with feed water pressure of 45psi or greater.
This RO unit has a 24 month warranty which is subject to our warranty terms and conditions and is installed with a pressure reducing valve and leak shut off device
If you are not entirely satisfied with your purchase please contact us so that we can try to resolve your concerns
